Spindle amplifier for Series 30i Additional Manual Page 1
Additional Manual
TECHNICAL REPORT (MANUAL) NO. TMS03/026E
Date July. 17. 2003
General Manager of
Servo Laboratory
Spindle amplifier for Series 30i
1. Distribute this report to the destinations marked with ○:
○
Your information
○
GE Fanuc-N, GE Fanuc-E
Fanuc Robotics-NA, Fanuc Robotics-E
CINCINNATI MILACRON
○
Machine tool builder
Sales agency
End user
2. Summary for Sales Documents
(Sales guide, Functional comparison list, etc.)
3. Notice
4. Attached Document
Drawing
No.
A-53866E-441(001/1)
5. Registration of Order List data (In case of Order List)
Type of
Data
Original Section of Issue
ADE
Manager Chief Person in
charge
←
FANUC
Contents Summary of Spindle amplifier for Series 30i Additional Manual
- Page 1TECHNICAL REPORT (MANUAL) NO. TMS03/026E Date July. 17. 2003 General Manager of Servo Laboratory Spindle amplifier for Series 30i 1. Distribute this report to the destinations marked with ○: ○ Your information ○ GE Fanuc-N, GE Fanuc-E Fanuc Robotics-NA, Fanuc Robotics-E CINCINNATI MILACRON ○ Machine
- Page 2Spindle amplifier for Series 30i 1. General With Series 30i, spindle position control (Cs contouring control, Rigid tapping) is executed with Nano interpolation. So it is necessary to apply new spindle software for Series 30i interface. Though the hardware specification of spindle amplifier for Seri