
Ed.
Date
Design Description
Name
Draw.
FANUC MANUAL GUIDE i
SPECIFICATION
A-90155
Page
6/3
2005.7.21
Correction of part2005.8.12
2.2 Tool detachment
In Magazine management table screen set magazine number and pot
number, and input the cause of tool detachment , so you can detach
tools.
If tool detachment is executed normally, it is performed as follows.
- tool data that belongs to the magazine number and pot number
inputed in the tool management table is deleted.
- a number of tool management data that belongs to the magazine
number and pot number inputed in the Magazine management
table is deleted.
- detachment history data is registered to the tool detachement history
data table.
Set the magazine number and the pot number, and press [DETACH]
soft-key, so you can detach tools.
When tool is detached, select and press soft-key from [CAUSE1] to
[CAUSE5] as follows, so you can detach tools.
INPUTOUTPUTDETACHATTACH
CANCELCAUSE5CAUSE3 CAUSE4CAUSE2CAUSE1