
B–63980EN/01
4. DESCRIPTION OF PARAMETERS
71
#7
3004
#6 #5
OTH
#4 #3 #2 #1 #0
[Data type] Bit
OTH The overtravel limit signal is:
0 : Checked
1 : Not checked
WARNING
For safety, usually set 0 to check the overtravel limit signal.
#7
3006
#6 #5 #4 #3 #2
EPS
#1
EPN
#0
GDC
[Data type] Bit
GDC As the deceleration signal for reference position return:
0 : X009 is used.
1 : G196 is used. (X009 is disabled.)
EPN Workpiece number search signals are assigned to:
0 : PN1, PN2, PN4, PN8, and PN16. <G009>
1 : EPN0 to EPN13. <G024, G025>
EPS When a program is searched using the workpiece number search function,
it is started by:
0 : Automatic operation start signal ST (when automatic operation
(memory operation) is started).
1 : Workpiece number search start signal EPNS <G025.7>. (Search is not
started by ST.)
3010 Time lag in strobe signals MF, SF, TF, and BF
[Data type] Word
[Unit of data] 1 ms
[Valid data range] 16 to 32767
The time required to send strobe signals MF, SF, TF, and BF after the M, S,
T, and B codes are sent, respectively.
M, S, T, B code
MF, SF, TF, BF, signal
Delay time
Fig.4.14 (a) Delay Time of the strobe signal
NOTE
The time is counted in units of 8 ms. If the set value is not
a multiple of eight, it is raised to the next multiple of eight.
Example
When 30 is set, 32 ms is assumed.
When 32 is set, 32 ms is assumed.
When 100 ie set, 104 ms is assumed.