7.PMC DIAGNOSIS AND MAINTENANCE SCREENS ([PMC MAINTE]) B-63983EN/02
- 718 -
7.4.17 Outputting PMC Parameters to the Memory Card
PMC parameters can be output from a PMC to the memory card. To
use this function, perform the operation described below on the I/O
screen.
NOTE
This operation can be performed only when the
operation condition allows PMC parameter output.
For details, see Section 6.2.
(1) On the I/O screen, make the following settings with the query
selection cursor and option selection cursor:
Query Setting
PMC (Output target PMC)
DEVICE MEMORY CARD
FUNCTION WRITE
KIND OF DATA PARAMETER
For the setting of an output target PMC, see Subsection 7.4.4.
(2) Move the query selection cursor to FILE NAME, then enter a
desired file name.
Enter a file name not longer than eight characters with a three-
character extension in the MS-DOS format. When no file name
is entered, the following file name is automatically set:
Output target PMC File name
PMC1 PMC1_PRM.000
PMC2 PMC2_PRM.000
PMC3 PMC3_PRM.000
Dual check safety PMCS_PRM.000
If a file with the same file name already exists, the extension
number is incremented for output.
Example:
PMC1_PRM.001