
B–63505EN/02
1. DISPLAY AND OPERATION
91
5. Press the [EXEC] soft key.
During output, “INPUT” blinks in the message field.
The screen cannot be changed to another screen during parameter
input/output.
When the RESET key is pressed, or when an alarm status is detected in
communication, the input/output stops.
When the Power Motion series is used as a slave of an I/O Link, the CNC
assigns I/O addresses. The salve data is input and output in units of 16
bytes. Therefore, 128 input/output points are necessary. Up to eight
slaves can be connected.
The module name is OC021 (16–byte input) or OC020 (16–byte output).
BASE is always 0, and SLOT is always 1.
After the data necessary for each slave connected is set and checked, the
communication of the power mate CNC manager (PMM) can be stopped
to send a command from the CNC ladder to the slave.
When the PMN bit (bit 3 of parameter 960) is set to 1, all communication
between CNC and the slave via the I/O Link is open to the ladder.
While the bit is held 1, the screen shows just the title, function name, and
other items that are independent of the communication. The following
message appears to indicate that communication has stopped.
COMMUNICATION PROHIBITED BY P960#3
(1)CNC
When a CNC alarm status is detected, the screen is automatically
switched to the CNC alarm screen. Check the details of the alarm. If
necessary, display and select the power mate CNC manager screen
again by pressing function key
SYSTEM
.
(2)Slave
A guidance message is usually displayed in the message field. If a
slave alarm is detected, the corresponding slave group number is
displayed at the right end.
Display the alarm screen to check the details.
When the data protection key of the CNC is turned on, parameters cannot
be input to CNC memory.
1.15.4
Notes
D Connecting an I/O Link
D Ignoring the power mate
CNC manager function
D Alarm
D Data protection key