This manual consists of following chapters.
1.DISPLAY AND OPERATION
This chapter covers those items, displayed on the screen, that are related
to maintenance. A list of all supported operations is also provided at the
end of this chapter.
This chapter covers hardware–related items, including the hardware
configuration, connection, and NC status indicated on printed circuit
boards. A list of all units is also provided as well as an explanation of how
to replace each unit.
3.INPUT AND OUTPUT OF DATA
This chapter describes the input/output of data, including programs,
parameters, and tool compensation data, as well as the input/output
procedures for conversational data.
4.INTERFACE BETWEEN NC AND PMC
This chapter describes the PMC specifications, the system configuration,
and the signals used by the PMC.
This chapter describes the servo tuning screen and how to adjust the
reference position return position.
These chapters describe the spindle amplifier checkpoints, as well as the
spindle tuning screen.
This chapter describes the procedures to be followed in the event of
certain problems occurring, for example, if the power cannot be turned on
or if manual operation cannot be performed. Countermeasures to be
applied in the event of alarms being output are also described.
A. ALARM LIST
B. LIST OF MAINTENANCE PARTS
C. BOOT SYSTEM
D. MEMORY CARD INTERFACE
E. MAINTENANCE OF OPEN CNC (BOOT–UP AND IPL)
This manual does not provide a parameter list. If necessary, refer to the
separate PARAMETER MANUAL (B–63510EN) .