
B–63505EN/02
3. INPUT AND OUTPUT OF DATA
129
1. Select MDI mode.
2. Press
OFFSET
SETTING
key then soft key [SETTING] to select a setting screen.
3. Set the cursor to PARAMETER WRITE and input
1
and
INPUT
.
At this time, alarm 100 will be generated.
4. Press
SYSTEM
key and soft key [PMC].
5. Press soft key [PMCPRM] and soft key [KEEPRL]
6. Set the cursor to K17 and set the first bit to 1.
X X X X X X
1
X
INPUT
Where, mark x is a former value
Thus, data input/output screen has been selected.
7. Select EDIT mode.
8. Press soft key
then key .
9. Press soft key [I/O] and set the parameters on I/O.
Item selection cursor moves to the following item after data of an item
is set.
10.In CHANNEL NO item, input
1
INPUT
to select I/O channel 1.
11. In DEVICE item, press soft key [FDCAS] to select the floppy cassette.
12.In KIND DATA item, press soft key [PARAM].
13.In FUNCTION item, press soft key [WRITE].
14.In FILE No item, specify a file name. In this example input as follows:
@ P
M
C
INPUT
15.Press soft key [EXEC]. Then PMC parameters are started to be output.
16.After the PMC parameters have been output, set PARAMETER
WRITE to 0.
17.Press
RESET
to release alarm 100.
1. Select EDIT mode.
2. Press
SYSTEM
key several times, press soft key [PARAM], and
[PITCH] to select the SETTING screen for pitch error amount.
3. Press soft key [(OPRT)] and
.
4. Press soft key [PUNCH] and [EXEC], then pitch error compensation
amount is started to be output.
3.2.3
Outputting PMC
Parameters
3.2.4
Outputting Pitch Error
Compensation Amount