
B–63505EN/02
4.INTERFACE BETWEEN NC AND PMC
167
3 SCOPE screen
PMC SIGNAL ANALYSIS(PARAM)
SGNPRM
START
MONIT RUN
SAMPLING TIME : 10 CONDITION : 1
TRIGGER ADDRESS : G0007.2 TRIGGER MODE : 0
T.SRCH ADDRESS
X0000.0
X0000.1
X0002.0
X0005.0
+–––––––––+–––––––––+–––––––––+––––––
+–––––––––+–––––––––+–––––––––+––––––
0 256(MSEC)
The above screen is for a system with graphic display.
“J” and “–” are used for display if graphic function is not equipped.
a. Soft key [SGNPRM] : Returns to parameter screen.
b. Soft key [START] or [STOP] :Start or stop the record.
(If TRIGGER MODE=3, signal is displayed when you press STOP
key.)
c. Soft key [T.SRCH] :Displayed for a specified time.
d. Soft key [ADDRESS] or [SYMBOL]:Switch addresses and
symbols for display
e. Soft key [EXCHG] : Change order of signals displayed.
S Press soft key [EXCHG]
S Move the cursor to a signal to be changed.
S Press soft key [SELECT].
S Move the cursor to the destination.
S Press [TO] and [EXEC], then the signal changes its order.
f. Soft key [SCALE]: Changes time scale for graphic display. Scale
changes from 256 to 512, and to 1024 msec every time you press the
key.
g. Cursor key
: Scrolls time axis forward and backward