
9
Edit
Apprv.
Apprv.Apprv.
Apprv.Desig.
Desig.Desig.
Desig.
Sheet
Title
Draw
No.
/
24
Date
DateDate
Date
Design
DesignDesign
Design
Descri
tion
Descri
tionDescri
tion
Descri
tion
Date
DateDate
Date
FANUC Series16i /18i /21i –MA/TA
Embedded Macro
A-77900E
2000.04.11
At meeting all the following requirements, the parameter number 12013 keyword
cannot be changed.
(1) There is a password. (Password ≠0)
(2) The range of the embedded macro program number in the embedded data of
FROM is different from the range of the embedded macro program number
in the parameters.
(3) The programs are registered.
5) Programs writing from DRAM to FROM
The embedded macro programs on DRAM are written in FROM by following
operation.
(1) Select the EDIT mode.
(2) Push the softkey [PROG].
(3) Push the softkey <OPRT>.
(4) Push the right side softkey several times.
(5) Push the softkey <SAVE>.
(6) Push the softkey <EXEC>.
When above operation is done, all the macro programs on DRAM are stored in
FROM in the lump as the file name "INMC". At the same time, the program
administrative information and the parameters of embedded macro are also stored in
"INMC" file in FROM.
The softkey <SAVE> is not displayed when the CNC is Lock State. Please be careful
that it is necessary to do the save operation if the macro programs are changed
because the edited programs are on DRAM area. So, when the CNC power supply is
turned off without storing in FROM, the edited programs are deleted.
6) Programs reading from FROM to DRAM
"INMC" file in FROM is loaded to DRAM for embedded macro program area when
the power supply is turned on. Then, the parameter No.12001-12049 for the
embedded macro function are rewritten by the data of "INMC" in FROM. After that,
the collation check on whether the program administrative information in both DRAM
and SRAM are matched each other is done. If the collation is not matched, all
embedded macro programs on DRAM are deleted.