B-64120EN/01 4.DESCRIPTION OF PARAMETERS
- 109 -
NOTE
1 If an incorrect value is set in this parameter, the
coordinate system cannot be established properly.
In this case, reverse the setting, and establish the
reference position again.
2 For an encoder with the absolute address zero
point (linear scale or rotary encoder) (detection
circuit C), the setting of this parameter is invalid.
TANx Tandem control
0 : Not used
1 : Used
NOTE
Set this parameter to both master axis and slave
axis.
#7 #6 #5 #4 #3 #2 #1 #0
1818 SDCx DG0x RF2x RFSx
[Data type] Bit axis type
RFSx When the reference position has not yet been established on an axis
for which an encoder with absolute address reference marks (linear
scale or rotary encoder) or encoder with the absolute address zero
point (linear scale or rotary encoder) (detection circuit C) is used, an
automatic reference position return (G28) causes the following
behavior after the reference position is established:
0: A movement to the reference position is made.
1: A movement to the reference position is not made, but the
operation is completed.
RF2x When the reference position has already been established on an axis
for which an encoder with absolute address reference marks (linear
scale or rotary encoder) or encoder with the absolute address zero
point (linear scale or rotary encoder) (detection circuit C) is used, an
automatic reference position return (G28) causes the following
behavior:
0: A movement to the reference position is made.
1: A movement to the reference position is not made, but the
operation is completed.
DG0x For an axis for which an encoder with absolute address reference
marks (linear scale or rotary encoder) is used, a reference position
return operation by a rapid traverse command or jog feed is:
0: Disabled.
1: Enabled.
SDCx An encoder with the absolute address zero point (linear scale or rotary
encoder) (detection circuit C) is:
0 : Not used.
1 : Used.