
4.DESCRIPTION OF PARAMETERS B-64120EN/01
- 348 -
1 : The amount of travel and feedrate are each specified with a
diameter.
NOTE
NDI is valid for an axis for which diameter
programming is specified (bit 3 (DIAx) of parameter
No. 1006 is set to 1) when bit 1 (CDI) of parameter
No. 8005 is set to 0.
#7 #6 #5 #4 #3 #2 #1 #0
8005 MFD IFV PVP DRR R10 CDI EDC
[Data type] Bit
EDC In PMC-based axis control, an external deceleration signal is:
0 : Disabled.
1 : Enabled.
CDI For PMC axis control, when diameter programming is specified for a
PMC-controlled axis:
0 : The amount of travel and feedrate are each specified with a
radius.
1 : The amount of travel is specified with a diameter while the
feedrate is specified with a radius.
NOTE
1 This parameter is valid when bit 3 (DIA) of
parameter No.1006 is set to 1.
2 When CDI is set to 1, bit 7 (NDI) of parameter
No.8004 is disabled.
R10 When the RPD parameter (bit 0 of parameter No.8002) is set to 1, the
unit for specifying a rapid traverse rate for the PMC axis is:
0 : 1 mm/min.
1 : 10 mm/min.
DRR For cutting feed per rotation in PMC axis control, the dry run function
is:
0 : Disabled.
1 : Enabled.
PVP For velocity command in PMC axis control, position control is:
0 : Not performed.
1 : Performed.
IFV Override for each group in PMC axis control is:
0 : Disabled.
1 : Enabled.
MFD Output by each auxiliary function of the PMC axis control function is:
0 : Disabled.
1 : Enabled.
#7 #6 #5 #4 #3 #2 #1 #0
8006 EAL EZR ESI IPA EML