Change of the Name of Open CNC Other Page 1
Other
TECHNICAL REPORT (MANUAL) No.TMN 01 /135E
Date. 2001/ .
General Manager of
Hardware Laboratory
The Name of Open CNC
1. Communicate this report to:
Your information
O
GE Fanuc-N, GE Fanuc-E
FANUC Robotics
CINCINNATI MILACRON
O
Machine tool builder ( dealt by GE Fanuc only)
O
Sales agency
O
End user
2. Summary for Sales Documents
3. Notice
4. Attached Document
Drawing
No.
A-82374E Rev.01001003/3
Order section of issuer
General
Manager
Vice
General
Manager
Department
Manager.
Section
Manager
P. in C
IDE
Contents Summary of Change of the Name of Open CNC Other
- Page 1TECHNICAL REPORT (MANUAL) No.TMN 01 /135E Date. 2001/ . General Manager of Hardware Laboratory The Name of Open CNC 1. Communicate this report to: Your information O GE Fanuc-N, GE Fanuc-E FANUC Robotics CINCINNATI MILACRON O Machine tool builder ( dealt by GE Fanuc only) O Sales agency O End user 2
- Page 2The Name of Open CNC 1. General We will change the definition of Open CNC's name as follows. 2. Definition of Open CNC's Name 1) "FANUC Open CNC" consists of following four types CNC, which are using FANUC PC function, and these model names are expressed with three-digit figures. 1 FANUC Series 160i
- Page 33. Order Specification of CNC Display Unit with Personal Computer Function According to the change of definition mentioned before, we will change the order specification of the basic unit for CNC display unit with personal computer function as follows. Please distinguish it with that of PANEL i (a p
- Page 44. Model Code in case of HSSB and other company's PC When CNC side HSSB board is ordered to use with other company's PC, three- digit model code has been used until now. From now on, when other company's PC is used as display unit of CNC, two-digit model name is applied to the CNC system even if the