1. Fanuc
  2. Outputting Signal Near End Point

Outputting Signal Near End Point Additional Manual Page 1

Additional Manual
A-59854
Edit
Apprv.
Apprv.Apprv.
Apprv.Desig.
Desig.Desig.
Desig.
Sheet
Title
Draw
No.
Date
DateDate
Date
Design
DesignDesign
Design
Descri
p
tion
Descri
p
tionDescri
p
tion
Descri
p
tion
Date
DateDate
Date
FANUC Series 16i /18i /21i –TA/TB
Outputting Signal near End point
1/3
FANUC Series 16i /18i / 21i–TA/TB
Outputting Signal near End Point
Previous page
Next page

Contents Summary of Outputting Signal Near End Point Additional Manual

  • Page 1FANUC Series 16i /18i / 21i–TA/TB Outputting Signal near End Point FANUC Series 16i /18i /21i –TA/TB Title Outputting Signal near End point Draw No. A-59854 Edit Date Design Description Sheet 1/3 Date Desig. Apprv.
  • Page 2Outline This function outputs the signal DEN2 when the tool approaches to the end point of a rapid traverse (G00) or linear interpolation (G01) block where a miscellaneous function (M–code) and a tolerable distance are commanded. As the miscellaneous function can be triggered near the end point by u
  • Page 3Parameter #7 #6 #5 #4 #3 #2 #1 #0 3405 QAB QLG PPS [Data type] Bit PPS The outputting signal near end point function is: 0 : Not used 1 : Used QLG When the outputting signal near end point function is used, the remaining distance to be traveled specified in address “,Q” is: 0 : The combined distance