Manual Guide M, Guide Advanced Programming
GE Fanuc Automation S.A. - 124 -
GFKE-0046-EN/01
8. 2. 2 Usage of COPY Function
Copy function can be used, to simplify data input for
Finishing, Chamfering or Pre-Hole drilling. The data
input menus are basically the same as roughing. If
roughing data are copied, only small modifications
are necessary to prepare data for other function,
like Finishing, Chamfering or Pre-Hole drilling.
Please see following procedure:
1. Move cursor to first function for roughing G301
(Tool setting)
2. Select Soft-Key COPY
3. Move cursor down to end of process G301
4. Select Soft-Key DECIDE
5. Select Soft-Key EXEC
Processes from
No. 3 (G301 T1. ***)
to end of
No. 5 (G210 P1. ***)
was copied as Process
No. 6 (G301 T1. ***)
to end of
No. 8 (G210 P1. ***)
6. Move cursor to Process No. 6 (G301 ***)
7. Select Soft-Key ALTER
Modify the content of
this 'Tool setting' menu.
e.g. from T1 to T2<
D1 to D2, R to 80
8. Modify process No. 7 (M3 S*** )
9. Modify process No. 8 (G210 P*** )
Important note
This method is maybe more easy and faster, then to input
all data completely. In case of copy the roughing process,
most data are the same as for finishing. Only some data
must be modified.
Original
Copy