8. DATA INPUT/OUTPUT
B–63854EN/03
OPERATION
432
When the floppy disk directory display function is used, the name of the
output file is PARAMETER.
Once all parameters have been output, the output file is named ALL
PARAMETER. Once only parameters which are set to other than 0 have
been output, the output file is named NON–0. PARAMETER.
Pitch error compensation data are loaded into the memory of the CNC
from a floppy or NC tape. The input format is the same as the output
format. See Section
8.6.4. When a pitch error compensation data is loaded
which has the corresponding data number as a pitch error compensation
data already registered in the memory, the loaded data replaces the
existing data.
Procedure for Pitch Error Compensation Data
1 Make sure the input device is ready for reading.
2 When using a floppy, search for the required file according to the
procedure in Section
III–8.2.
3 Press the EMERGENCY STOP button on the machine operator’s
panel.
4 Press function key
OFFSET
SETTING
.
5 Press the soft key
[SETING] for chapter selection.
6 Enter 1 in response to the prompt for “PARAMETER WRITE
(PWE)” in setting data. P/S alarm (No. 100 (indicating that
parameters can be written)) appears.
7 Press soft key
SYSTEM
.
8 Press the rightmost soft key
(continuous menu key)and press
chapter selection soft key
[PITCH].
9 Press soft key
[(OPRT)].
10 Press the rightmost soft key
(continuous menu key).
11 Press soft keys
[READ] and [EXEC].
Pitch error compensation data are read into memory. Upon
completion of input, the ”INPUT” indicator at the lower–right corner
of the screen disappears.
12 Press function key
OFFSET
SETTING
.
13 Press soft key
[SETING] for chapter selection.
14 Enter 0 in response to the prompt for “PARAMETER WRITE
(PWE)” of setting data.
15 Turn the power to the NC back on.
D Output file name
8.6.3
Inputting Pitch Error
Compensation Data