FANUC Series 30i /300i /300i s MAINTENANCE MANUAL, Correction of Description for Diagnosis Function Supplement to Manual Page 1
Supplement to Manual
TECHNICAL REPORT (MANUAL) ＮＯ．ＴＭＮ 06／004 E
Date 2005.12.29
General Manager of
Software Research Laboratory
FANUC Series 30i /300i /300i s MAINTENANCE MANUAL
Correction of description for Diagnosis function
１．Communicate this report to:
○ Your information only
○ GE Fanuc-N, GE Fanuc-E
FANUC Robotics
CINCINNATI MILACRON
○ Machine tool builder
Sales agency
End user
２．Summary for Sales Documents
３．Notice
The description of chapter 1.3.2 of FANUC Series 30
i/300i/300is MAINTENANCE MANUAL
is corrected.
４．Attached Document
Drawing
No.
B-63945EN/02-06
Original section of issue
Vice General
Manager
Section
Manager
Person in
Charge
ＦＡＮＵＣ
ADE
No. SRLB2-05/C225
Date Dec.29.2005
Contents Summary of FANUC Series 30i /300i /300i s MAINTENANCE MANUAL, Correction of Description for Diagnosis Function Supplement to Manual
- Page 1TECHNICAL REPORT (MANUAL) ＮＯ．ＴＭＮ 06／004 E Date 2005.12.29 General Manager of Software Research Laboratory FANUC Series 30i /300i /300i s MAINTENANCE MANUAL Correction of description for Diagnosis function １．Communicate this report to: ○ Your information only ○ GE Fanuc-N, GE Fanuc-E FANUC Robotics C
- Page 21.3 DIAGNOSIS FUNCTION 1.3.1 Displaying Diagnosis Screen (1) Press SYSTEM key. (2) Press soft key [DGNOS], then a diagnosis screen is displayed. 1.3.2 Contents Displayed • Causes when the machine does not travel in spite of giving a command 0000 #0 INPOSITION CHECK Inposition check is being done. #1