2. FUNCTION SPECIFICATIONS THAT DIFFER
FROM THE M series
Punching starts once positioning has been completed.
A rapid traverse rate is overridden by the following values when a switch
is pressed on the machine operator’s panel:
25%, 50%, 75%, 100%
The LRP bit (bit 1 of parameter 1401) cannot be used.
In automatic rapid traverse, the rapid traverse rate, time constant, and
servo loop gain can be varied according to the positioning distances for
individual axes, as specified in the parameters. By using this function,
positioning accuracy can be improved. (Up to seven levels)
In automatic rapid traverse, positioning for the X– and Y–axes can be
executed in a specified period, independently of the positioning distance.
If this function is used in nibbling mode, positioning can always be
completed within a specified period, irrespective of the length of the
nibbling pitch. This enables smooth punching. (Two levels)
This function is invalid for PMC–controlled axes.
Rapid Traverse Rate
Changing the Rapid
Traverse Rate, Time
Constant, and Servo
Loop Gain According
to the Positioning