
B–62444E–1/04
1. MACHINING PROGRAMS FOR
2–AXES (X AND Z AXIS) LATHES
TYPES OF MACHINING
PROGRAMS
259
(8) ROUND
Pressing the [ROUND] soft key selects a corner radius.
ROUND RADIUS R:
Corner radius
NOTE
5 When a round corner is specified, “ROUND” is displayed on
the screen until the next contour is entered.
ROUGHNESS SR: The roughness of the finished face is selected
by the soft key. The roughness specified by
the process data is set automatically.
(9) TANGNT
Pressing the [TANGNT] soft key specifies that the next contour form
a tangent to the previous contour (either contour must be an arc).
NOTE
6 Be sure to specify a straight line or arc for the next contour.
When a contact point is specified, “TANGNT” is displayed
on the screen.
(10) End of contour input
Upon completion of the necessary contour input, press [FIGURE
END]. Then, the cursor moves to the next process.