
A. PARAMETERS
B–62444E–1/04
APPENDIX
586
CSF During NC program conversion, NC program display and product figure
drawing are:
1 : Enabled.
0 : Disabled.
NZM Screen magnification according to the specified coordinates of the center
of the screen and magnification is:
1 : Enabled. (The conventional screen magnification is disabled.)
0 : Disabled.
ANM On the graphic screen, the continuous–state G code and remaining
traveling distance are:
1 : Indicated.
0 : Not indicated.
#7
6501
#6 #5
CSR
#4 #3 #2 #1 #0
CSR The cursor that appears on the magnified screen is:
1 : A cross (×).
0 : A square (j).
#7
6502
#6 #5 #4 #3 #2 #1
GRY
#0
HSA
HSA High–speed machining simulation drawing is:
1 : Enabled.
0 : Disabled.
D Usually, set this bit to 1.
GRY Animated simulation for Y–axis machining is:
1 : Enabled.
0 : Disabled.
D When the Y–axis machining function is supported, set this bit to 1.
6509 Drawing coordinate system: GRPAXS (for one–spindle two–turret lathe)
GRPAXS Drawing coordinate system for the graphic function for a one–spindle
two–turret lathe (Applicable to both tool posts)
<Related parameter: Bit 1 (SP2) of No. 6500>
11: The programmed zero point is on the end face of the chuck. The X1
axis is displayed in the upper part of the screen.
12: The programmed zero point is on the end face of the chuck. The X1
axis is displayed in the lower part of the screen.
14: The programmed zero point is on the end face of the workpiece. The
X1 axis is displayed in the upper part of the screen.
15: The programmed zero point is on the end face of the workpiece. The
X1 axis is displayed in the lower part of the screen.