
B–62444E–1/04
6. CREATING MACHINING PROGRAMS
OPERATION
69
(2) Selecting a figure
A menu of figures appears on the lower part of the screen. Select a
figure by pressing the corresponding soft key.
<
°
± ²
ROUND PLOT³ CHAMFR
+
<
¾
½ ¼
PLOT
¿ TANGNT
FIGURE
END
+
(3) Entering contour data
When a figure has been selected, the window guidance for entering
contour figure data appears as shown below. Enter the data that is
designated on the drawing.
Position the cursor at the item for specifying the angle, then enter the
following:
30
INPUT (angle of the diagonal line)
[INSERT]
INSERT TOOL–
D
PLOTCANCEL DETAIL
DATA
LENGTH
DIRECTION B=
TAPER END X CORD. X=
TAPER END Z CORD. Z=
COMPONENT X I=
COMPONENT Z/ANGLE K/J=30.000
LENGTH Q=
ROUGHNESS(1 ∼ 10 ) SR=4
CONTR FORM(TAPER LINE)
¾
(4) Displaying the figure data screen
When contour data is entered as mentioned above, the intersections
and other necessary data are calculated automatically and displayed
on the screen.
Repeat the above operation until all the data necessary for the
process is entered. Then press the [FIGURE END] soft key.