
4. DESCRIPTION OF PARAMETERS
B–63610EN/01
192
No. Parameters for SUB spindle if the spindle switch function is provided
(No.4176 to 4283)
Data type
4257 Word Output limit value for the motor output specification
4258 Word Base speed
4259 Word Magnetic flux weakening start velocity
4260 Word Current loop proportional gain
4261 Word Current loop integral gain
4262 Word Current loop integral gain zero speed
4263 Word Current loop proportional gain velocity factor
4264 Word Current conversion constant
4265 Word Secondary current factor for exciting current
4266 Word Current expectation constant
4267 Word Slip constant
4268 Word High–speed rotation slip compensation constant
4269 Word Compensation constant of voltage applied to motor in the dead zone
4270 Word Electromotive force compensation constant
4271 Word Electromotive force phase compensation constant
4272 Word Electromotive force compensation velocity factor
4273 Word Time constant for changing the torque
4274 Word Load meter displayed value for maximum output
4275 Word Maximum output limit zero speed
4276 Word Secondary current factor during rigid tapping
4277 Word Compensation factor for the phase of the electromotive force during deceleration
4278 Word Velocity detection filter time constant
4279 Word Load meter displayed value at maximum output (low–speed winding)
4280 Word Time constant of voltage filter for electromotive force compensation
4281 Word Spindle load monitor torque constant (for low–speed characteristics on the MAIN side)
4282 Word Spindle load monitor torque constant (for high–speed characteristics on the SUB side)
4283 Word Spindle load monitor torque constant (for low–speed characteristics on the SUB side)