
4. DESCRIPTION OF PARAMETERS
B–63610EN/01
258
#7
SBV
6000
#6 #5
SBM
SBM
#4
HGO
HGO
#3
V15
#2 #1
MGO
MGO
#0
G67
G67SBV
[Data type] Bit
G67 If the macro continuous–state call cancel command (G67) is specified
when the macro continuous–state call mode (G66) is not set:
0 : P/S alarm No.122 is issued.
1 : The specification of G67 is ignored.
MGO When a GOTO statement for specifying custom macro control is
executed, a high–speed branch to 20 sequence numbers executed from the
start of the program is:
0 : A high–speed branch is not caused to n sequence numbers from the
start of the executed program.
1 : A high–speed branch is caused to n sequence numbers from the start
of the program.
V15 As system variable numbers for tool offset:
0 : The standard system variable numbers for the Series 16 are used.
1 : The same system variable numbers as those used for the Series 15 are
used.
The tables below indicate the system variables for tool offset numbers 1 to
999. The values for tool offset numbers 1 to 200 can be read from or
assigned to the system variables in parentheses.
(1) Tool offset memory A
System parameter number
V15 = 0 V15 = 1
Wear offset value #10001 to #10999
(#2001 to #2200)
#10001 to #10999
(#2001 to #2200)
(2) Tool offset memory B
System parameter number
V15 = 0 V15 = 1
Geomentry offset value #11001 to #11999
(#2201 to #2400)
#10001 to #10999
(#2001 to #2200)
Wear offset value #10001 to #10999
(#2001 to #2200)
#11001 to #11999
(#2201 to #2400)
(3) Tool offset memory C
System parameter number
V15 = 0 V15 = 1
H–Code
Geomentry
offset value
#11001 to #11999
(#2201 to #2400)
#10001 to #10999
(#2001 to #2200)
Wear offset value #10001 to #10999
(#2001 to #2200)
#11001 to #11999
(#2201 to #2400)
D–Code
Geomentry
offset value
#13001 to #13999 #12001 to #12999
Wear offset value #12001 to #12999 #13001 to #13999
4.30
PARAMETERS OF
CUSTOM MACROS