
B–63610EN/01
4. DESCRIPTION OF PARAMETERS
89
CCI The in–position area for cutting feed is:
0 : Set in parameter No.1826 (same as for rapid traverse).
1 : Set in bit 5 (CIN) of parameter No.1801.
CIN When bit 4 (CCI) of parameter No.1801 = 1, the in–position area for
cutting feed is:
0 : Use value in parameter No.1827 if the next block is also for cutting
feed, or use value in parameter No.1826 if the next block is not for
cutting feed.
1 : Use value in parameter No.1827, regardless of the next block. (The
setting of parameter No.1826 is used for rapid traverse, and the setting
of parameter No.1827 is used for cutting feed.)
#7
1802
#6 #5
DPS
#4
B15
B15
#3 #2
DC2
DC2
#1 #0
CTS
FWC
NOTE
After this parameter is set, the power needs to be turned off.
[Data type] Bit
CTS The servo motor–based speed control function is:
0 : Not used
1 : Used
DC2 The reference position on the linear scale with absolute addressing
reference marks is established:
0: As determined by bit 1 (DC4) of parameter No. 1802.
1: By establishing the absolute position through detection of two
reference marks.
B15 In backlash compensation, the travel direction is determined:
0: Without consideration of the compensation amount (pitch error,
straightness, external machine coordinate shift, etc.).
1: In consideration of the compensation amount. (FS15 format)
DPS When servo motor–based speed control is applied, a position coder is:
0 : Used
1 : Not used
FWC The processing of command multiplication (CMR) is performed:
0: After acceleration/deceleration after interpolation.
1: Before acceleration/deceleration after interpolation.
#7
1803
#6 #5 #4
TQF
#3 #2 #1
TQA
#0
TQI
[Data type] Bit
TQI While torque restriction is applied, in–position check is:
0 : Performed.
1 : Not performed.
TQA While torque restriction is applied, checking for an excessive error in the
stopped state/during movement is:
0 : Performed.
1 : Not performed.