Fanuc Series 16i /18i Additional Manual Page 4
Additional Manual
#7 #6 #5 #4 #3 #2 #1 #0
7103 HIE
[Data type] Bit type
HIE The specification of the acceleration/deceleration of the manual handle interruption is
as follows.
0: Acceleration/deceleration type and the time constant are the same as those of the
automatic operation.
1: Acceleration/deceleration type is the same as that of the manual feed.
(Acceleration/deceleration type is decided by setting the parameter JGL
(No.1610#4), CTB(No.1610#1) and CTL(No.1610#0).)
The time constant is set to parameter No.1624 and the FL feedrate is set to
parameter No.1625. And parameter IHD (No.7100#2) should be set to “1”.
4 Restrictions
(1) Manual handle interrupt cannot be done during the 5-axis machining function
mode. The 5-axis machining modes are as follows.
- Tool center point control for 5-axis machining
- Tool radius compensation for 5-axis machining
- Tool center point control
- Tool length compensation along tool direction
- 3 dimensional cutter compensation
- 3 dimensional circular interpolation
- Each function which sets by parameter No.19600, and is executed by RISC
Scaling function
Programmable mirror image function
Rotary table dynamic fixture offset function
Coordinate rotation function
Three dimensional coordinate conversion function
Tool radius compensation C function
Tilted working plane command function
(2) This function is available by combination of the following CNC software and RISC
software.
[CNC software]
- B0F4/BDF4-18 or later (FS16i /18i - MA)
- B0HA/BDHA-09 or later (FS16i/18i - MB)
- BDH5-24 or later (FS18i - MB5)
[RISC software for AI high precision contour control]
- B45A-05 or later
A-79259EN
Edit
Apprv.
Desig.
Sheet
Title
Draw
No.
Date
Design
Description
Date
FANUC Series 16i/18i–MA/MB, 18i–MB5
Improvement of AI/AI NANO HPCC function
(Manual handle interruption) Specifications
Oct.28.2003
3/3
Sheet
Sheet
Contents Summary of Fanuc Series 16i /18i Additional Manual
- Page 1TECHNICAL REPORT NO.TMN 03/090E Date : Oct.29.’03 General Manager of Software Development Center FANUC Series 16i /18i – MA/MB, 18i-MB5 Improvement of AI High Precision Contour Control / AI NANO High Precision Contour Control function (Manual handle interruption) 1. Communicate this report to : Your
- Page 2FANUC Series 16i/18i–MA/MB FANUC Series 18i–MB5 Improvement of AI High Precision Contour Control function / AI NANO High Precision Contour Control function (Manual handle interruption) Specifications - Contents - 1 GENERAL..............................................................................
- Page 31 General The manual handle interruption is available during the AI high precision contour control / AI nano high precision contour control mode. 2 Specifications The manual handle interruption has the following three acceleration /deceleration types. The specification of each acceleration/decelerat
- Page 4#7 #6 #5 #4 #3 #2 #1 #0 7103 HIE [Data type] Bit type HIE The specification of the acceleration/deceleration of the manual handle interruption is as follows. 0: Acceleration/deceleration type and the time constant are the same as those of the automatic operation. 1: Acceleration/deceleration type is