B–63835EN/03
1. DISPLAY AND OPERATION
77
#7
517
#6 #5 #4 #3
THH
#2
THL
#1 #0
PRA
DGN
Indicates the internal information about the HSSB (channel 2) as follows.
#0(PRA): 0 : Normal
1 : A RAM parity error has occurred in shared RAM.
#3, #2(THL, THH):
THL THH Status
0 0 A battery alarm has occurred in the PANEL i or CNC dis-
play unit with PC functions.
1 0 A high–temperature condition has occurred in the PANEL i
or CNC display unit with PC functions.
0 1 A low–temperature condition has occurred in the PANEL i
or CNC display unit with PC functions.
1 1 Normal (connected to the PC)
#4: 0 : Normal
1 : An NMI has occurred in the HSSB.
#7
518
#6 #5 #4 #3 #2 #1 #0
DGN
Indicates the internal information about the HSSB (channel 2). (Hidden
function)
520 Total number of retractions during cutting after G83 is specified
DGN
Executing the G83 command clears the value to zero.
Total number of retractions made by receiving the overload signal during cutting
after G83 is specified
521
DGN
Executing the G83 command clears the value to zero.
522 Position on the drill axis from which retraction is started
DGN
The units are the same as the minimum input increment.
Difference between the position on the drill axis from which the previous retraction
was started and the position from which the current retraction is started
523
DGN
The units are the same as the minimum input increment.
D Diagnostic data related
to a small–diameter peck
drilling cycle (M series
only)