1. DISPLAY AND OPERATION
B–63835EN/03
78
Difference in the position error between the master and slave axes in simple synchro-
nas control
540
DGN
Difference in the position error between the master and slave axes in simple synchro-
nas control
541
DGN
DGN 540 indicates the difference in the position error between the master
and slave axes when a single axis pair is subjected to simple synchronous
control. DGN 541 is used when two or more pairs are subjected to simple
synchronous control. The position error is indicated for the master axis.
DGN 540 and 541 indicate values in detection units. They are displayed
only with the M series.
560 Status after execution of manual tool compensation
DGN
0 : Manual tool compensation ended normally.
1 : The data of the T code command is out of the allowable range.
2 : The offset value is out of the allowable range.
3 : The offset number is out of the allowable range.
4 : The CNC is running automatically or moving the axes.
5 : The CNC is in tool tip radius compensation mode.
6 : The CNC is not in JOG or HNDL (INCR) mode.
7 : The setting of a CNC parameter is invalid.
#7
CFE620
#6 #5
ERR
#4
ERP
#3
OPN
#2
RDY
#1
OPP
#0
CLS
DGN
Indicates the internal status of the FSSBC2.
#0(CLS): Closed.
#1(OPP): Running OPEN protocol.
#2(RDY): Open and ready.
#3(OPN): Open.
#4(ERP): Running ERROR protocol.
#7(CFE): Encountered configuration error.
(The actual slave type does not match the one specified in the conversion
table.)
D Diagnostic data related
to simple synchronous
control
D Status after execution of
manual tool
compensation (for the T
series only)
D FSSB2 status