
23. PART PROGRAM STORAGE
AND EDITING
B–63172EN/01
NC FUNCTION
152
The following editing is possible.
D Conversion
- Address conversion
An address in the program can be converted to another address. For
example address X in the program can be converted to address Y.
- Word conversion
A word in the program can be converted to another word. For
example, a programmed M03 can be converted to M04.
D Program copy
A part or all of a program can be copied to make a new program.
D Program move
A part or all of a program can be moved to make a new program.
D Program merge
A new program can be created by merging two programs.
Number of registered programs can be selected from the following:
63, 125, 200, or 400.
The following part program storage length can be selected:
10, 20, 40, 80, or 160 m.
Program can be prepared by storing machine position obtained by manual
operation in the memory as program position. Data other than the
coordinate value (M codes, G codes, feed rates, etc.) are registered in the
memory by the same operation as part program storage and editing.
Part program registration and punch can be commanded externally.
D Program registration
A part program can be registered in memory through the connected
input device for background editing using the external read start
signal.
D Program punch
A part program can be punched through the connected output device
for background editing using the external punch start signal.
23.3
EXPANDED PART
PROGRAM EDITING
23.4
NUMBER OF
REGISTERED
PROGRAMS
23.5
PART PROGRAM
STORAGE LENGTH
23.6
PLAY BACK
23.7
EXTERNAL
CONTROL OF I/O
DEVICE