PROGRAMMING18. SPECIFYING THE LASER FUNCTION
B–63664EN/02
368
If portions at or around a corner that are left uncut in edge cutting, setting
bit 2 of parameter No. 15007 or bit 7 of parameter No. 15012 to 1 may
improve this phenomenon.
If you want to perform edge cutting even in the exact stop mode, set bit
4 of parameter No. 15007 to 1.
If you want to enable the edge cutting function to be used together with
the arc radius–based feedrate clamp function, set bit 7 of parameter No.
15010 to 1.
(1)The machining condition setting function option must be prepared.
(2)When this function is used, the automatic corner override function
cannot be used.
(3)This function and automatic corner deceleration cannot be used at the
same time.
(4)In single block and dry run operations, this function does not work.
(5)This function is valid only for facing. This function cannot be
specified in circular interpolation, normal direction control, and
three–dimensional machining commands.
[Classification] Output signal
[Function] This signal indicates that machining is being performed for the return
distance.
[Operation] This signal is set to 1 when machining is being performed for the return
distance in edge machining and startup machining. After machining for
the return distance is completed, the signal is set to 0.
#7
F223
#6
STUP
#5 #4 #3 #2 #1 #0
#7
15004
#6 #5 #4
EDG
#3 #2 #1 #0
[Data type] Bit
EDG When the assist gas is switched in edge machining, the beam is:
0 : Turned off.
1 : Not turned off.
Other settings related to
cutting
Limitations
Signal
D Constant optical path
length control start
signal
STUP<F223#6>
Signal address
Parameters