OPERATION
B–63664EN/02
12. GRAPHICS FUNCTION
747
7 Press soft keys [+ROT] [–ROT] [+TILT], and [–TILT], when
performing drawing by changing the drawing directions. Parameters
P and Q for the drawing direction are changed and the figure is
redrawn with the new parameters.
8 Set the operation mode to the memory mode, press function key
PROG
, and call the subject part program of drawing.
9 To draw a machining profile, display the
SOLID GRAPHIC
(EXECUTION) screen by pressing soft key [EXEC] on the SOLID
GRAPHIC (PARAMETER) screen of step 1 above.
SOLID GRAPHIC (EXECUTION)
Z
Y
X
O1126 N01126
A.ST
F.ST
STOP REWIND
O1126 N01126
Y
X
SOLID GRAPHIC (EXECUTION)
A.ST
F.ST
STOP REWIND
10 Press soft key [(OPRT)] and press either soft key [A.ST] or [F.ST].
When
[A.ST] is pressed, the status of machining in progress is drawn
by simulation. When
[F.ST] is pressed, the profile during machining
is not drawn. Only the finished profile produced by the program is
drawn. This allows drawing to be started.
When “
STOP” is not displayed at the lower right corner of the screen,
the program is executed from its head. “
DRAWING” blinks at the
lower right corner of CRT screen during drawing.
D SOLID GRAPHICS
(EXECUTION)