OPERATION12. GRAPHICS FUNCTION
B–63664EN/02
750
Set the type of blank figure under P. The relationship between the setting
value and figure is as follows:
P Blank figure
0 Rectangular parallelepiped (Cubed)
1 Column or cylinder (parallel to Z–axis)
Set the X–axis, Y–axis, and Z–axis coordinate values of standard point
of materials in workpiece coordinate system to the addresses X, Y, and Z.
The standard point of materials is the corner point in the negative
direction in the case of rectangular parallelepiped blank figure and the
center point of bottom in the case of column and cylinder materials.
Set the dimensions of materials. The relationship between the addresses
I, J, and K and setting value is as shown below:
Material I J K
Rectangular Length in X–axis
direction
Length in Y–axis
direction
Length in Z–axis
direction
Column Radius of circle 0 Length of column
Cylinder Radius of external
circle
Radius of internal
circle
Length of cylinder
Z
K
Y
J
I
(X,Y,Z)
J
I
X
(X,Y,Z)
K
Explanations
GRAPHICS PARAMETER
D BLANK FORM
♦ BLANK FORM (P)
♦ Material positions
(X,Y,Z)
♦ Material dimensions
(I,J,K)