PROGRAMMING
4. INTERPOLATION FUNCTIONS
B–63664EN/02
58
Linear interpolation can be commanded by specifying axial move
following the G31 command, like G01. If an external skip signal is input
during the execution of this command, execution of the command is
interrupted and the next block is executed.
The skip function is used when the end of machining is not programmed
but specified with a signal from the machine. It is used also for measuring
the dimensions of a workpiece.
G31 _ ;
G31: One–shot G code (If is effective only in the block in which it
is specified)
IP
The coordinate values when the skip signal is turned on can be used in a
custom macro because they are stored in the custom macro system
variable #5061 to #5068, as follows:
#5061 X axis coordinate value
#5062 Y axis coordinate value
#5063 Z axis coordinate value
#5064 4th axis coordinate value
#5065 5th axis coordinate value
#5066 6th axis coordinate value
#5067 7th axis coordinate value
#5068 8th axis coordinate value
WARNING
Disable feedrate override, dry run, and automatic
acceleration/deceleration (however, these become available
by setting the parameter SKF No.6200#7 to 1.) allowing for
an error in the position of the beam when a skip signal is
input.
To disable beam output, set parameter No. 15004#2 to 1.
NOTE
If G31 command is issued while cutter compensation C is
applied, an P/S alarm of No.035 is displayed. Cancel the
cutter compensation with the G40 command before the G31
command is specified.
4.10
SKIP FUNCTION
(G31)
Format
Explanations