
09 00.11.21 K.Yamamuro Revised to edition 09
08 00.06.22 T.Watanabe Revised to edition 08 T.Endo
01 99.03.10 K.Yamamuro New-registered T.Endo
A-63537E
ED DATE DESIG.
DESCRIPTION 41/134
SHEET
TITLE
FANUC Series 16i/18 i -TA
Compound Machining Function
TITLE
CUST.DRAW.NO.
Turning : 1
st
axis X
2
nd
axis Z
3
rd
axis C
4
th
axis Y
Milling : 1
st
axis X
2
nd
axis Y
3
rd
axis Z
4
th
axis C
2.8.2 DO signals
DO signals of Compound Machining Function are had in common in turning
mode and milling mode. DO signals for milling mode is output to F000 and
after only in milling mode.
The half-tone dot meshing ( )has been described on the
non-effective signal in one side.
Please input the DO signal of the axis type based on the axis on the turning
mode.
The half-tone dot meshing ( )has been described on the
corresponding signal.
Example 1)
TF, SF, EFD are common signals. BF(#4) is the signal of turning mode.
BF(#7), MF are the signals of milling mode.
Address 7 6 5 4 3 2 1 0
F007 BF BF TF SF EFD MF
Example 2)
The DO signal of the axis type is output based on the axis on the turning
mode.
When the same name as the motors in both modes was named as the above-
mentioned, MV2 signal is output both in moving 2
nd
axis (Z) in turning mode
and in moving 3
rd
axis (Z) in milling mode.
Address
7 6 5 4 3 2 1 0
F102 MV8 MV7 MV6 MV5 MV4 MV3 MV2 MV1