
4.CONFIRMATION OF THE OPERATION START-UP PROCEDURE B-65285EN/03
- 30 -
4.3.1 STATUS Display
ALM
ERR
STATUS
No. ALM ERR STATUS Description
1
No
indication
The control power supply has not been
switched on.
The power supply circuit is defective. See
Section 3.1.2.
250
For about 1.0 s after the control power
supply is switched on, the lower two digits of
the spindle software series No. are
indicated.
Example) 50: Software series No. 9D50
304
The spindle software edition number is
displayed for about 1.0 s. 01, 02, 03, and so
on correspond to A, B, C, and so on,
respectively.
Example) 04: software edition D
4
--
Blinking
The CNC has not been switched on.
The machine is waiting for serial
communication and parameter loading to
end.
5
--
Lighting
Parameter loading has ended.
The motor is not supplied with power.
6 00 The motor is supplied with power.
7 Lighting
01 or
above is
displayed.
Alarm state
The SPM is not operable.
See Chapter 1 of Part II.
8 Lighting
01 or
above is
displayed.
Error state
Incorrect parameter setting or improper
sequence.