8. AUXILIARY FUNCTION
B–64113EN–1/01
490
NOTE
1 When a move command and miscellaneous function are
specified in the same block, the commands are executed in
one of the following two ways:
i) Simultaneous execution of the move command and
miscellaneous function commands.
ii) Executing miscellaneous function commands upon
completion of move command execution.
The selection of either sequence depends on the
sequence of PMC.
2 The address used for specifying the 2nd auxiliary function
(B or the address specified with parameter No. 3460)
cannot be used as an axis address.
3 The block following M00, M01, M02 and M30, is not read
into the input buffer register, if present. Similarly, ten M
codes which do not buffer can be set by parameters (No.
3411 to 3420).
4 For M00 and M01 only, miscellaneous function code signal,
auxiliary function strobe signal, and M decode signals are
sent; the control of program stop and optional stop shall be
designed on the PMC side.
5 When the automatic operation is stopped by M02 or M30,
it is necessary to send the external reset signal from the
machine side to the CNC, instead of the FIN signal, When
the external reset signal is returned against the M02 or M30,
the control returns to the top of the program recently
executed and enters the reset state. When the FIN signal
is returned, the control returns to the beginning of the
program recently executed and executes it from the top.
OPERATOR’S MANUAL
(M series) (B–64124EN)
II.11.1 Miscellaneous function (M code)
(M series) (B–64124EN)
II.11.3 2nd Auxiliary function (B code)
OPERATOR’S MANUAL
(T series) (B–64114EN)
II.11.1 Miscellaneous function (M code)
(T series) (B–64114EN)
II.11.3 2nd Auxiliary function (B code)
OPERATOR’S MANUAL
(M series) (B–64144EN)
II.11.1 Miscellaneous function (M code)
(M series) (B–64144EN)
II.11.3 2nd Auxiliary function (B code)
OPERATOR’S MANUAL
(T series) (B–64134EN)
II.11.1 Miscellaneous function (M code)
(T series) (B–64134EN)
II.11.3 2nd Auxiliary function (B code)
Note
Reference item