Series 16i/18i/21i Additional Manual Page 1

Additional Manual
FANUC Series 16i
/
18i
/
21i
B
FANUC Series 18i – MB5
FANUC Series 0i – B
Manual handle feed magnification for each axis
Specifications
- Contents -
1 GENERAL.........................................................................................................................................................2
2 PARAMETERS .................................................................................................................................................3
3 NOTES..............................................................................................................................................................4
1
/
4
Edit
Apprv. Desig.
Sheet
Title
Draw
No.
Date
Design
Descri
p
tion
Date
May.17.2004
Sheet
FS16i/18i/21i - B, 18i - MB5, 0i - B
Manual handle feed magnification for each axis
Specifications
A-78860E

Contents Summary of Series 16i/18i/21i Additional Manual

  • Page 1FANUC Series 16i/18i/21i – B FANUC Series 18i – MB5 FANUC Series 0i – B Manual handle feed magnification for each axis Specifications - Contents - 1 GENERAL................................................................................................................................................
  • Page 21. General By this function, the manual handle feed magnification m, n can be set for each axis individually with setting the parameter No.12350 and No.12351. When the parameter No.12350 is set to “0”, the parameter No.7113 is used for the magnification m and when the parameter No.12351 is set to “0
  • Page 32. Parameters 12350 Manual handle feed magnification m for each axis [Data type] Word axis [Unit of data] One time [Valid data range] 1 to 127 This parameter sets the magnification for each axis when manual handle feed movement selection signal MP1 and MP2 are set to “0” and “1”. When this parameter
  • Page 43. Notes 1. As for the following functions, the manual handle feed magnification for each axis can not be used. In this case, the parameter No.7113 and No.7114 (manual handle feed magnification for all axes) are used. Manual linear / circular interpolation Manual feed for 5-axis machining Manual han