1. Fanuc
  2. FS 16/18/160/180-MB Concerning the Correction of Rigid Tapping (G84) / Left-handed rigid tapping cycle (G74)

FS 16/18/160/180-MB Concerning the Correction of Rigid Tapping (G84) / Left-handed rigid tapping cycle (G74) Supplement to Manual Page 3

Supplement to Manual
2/2
PAGEEDT.
DATE
DESIGN
DESCRIPTION
TITLE
No.
FANUC Series 16/18-MA/MB
OPERATOR'S MANUAL
Concerning the correction of Rigid tapping(G84)
/ Left-handed rigid tapping(G74)
B-62454E/04-01 B-61874E/04-01
01 02.08.21 T.Inagaki Newly Registered
Outline
Descriptions are changed as follows.
1. The description of "Thread lead" on "14.2.1 Rigid tapping
(G84)" is replaced.
2. The description of "Thread lead" on "14.2.2 Left-Handed
Rigid tapping Cycle (G74)" is replaced.
Details
1. The description of "Thread lead" on "14.2.1 Rigid tapping (G84)" is replaced
as follows.
Thread lead
In feed-per-minute mode, the thread lead is obtained from the
expression, feedrate÷spindle speed. In feed-per-revolution mode, the
thread lead equals the feedrate speed.
If a tool length offset (G43,G44 or G49) is specified in the canned
cycle, the offset is applied at the time of positioning to point R.
2. The description of "Thread lead" on "14.2.2 Left-Handed Rigid tapping Cycle
(G74)" is replaced as follows.
Thread lead
In feed-per-minute mode, the thread lead is obtained from the
expression, feedrate÷spindle speed. In feed-per-revolution mode, the
thread lead equals the feedrate speed.
If a tool length offset (G43,G44 or G49) is specified in the canned
cycle, the offset is applied at the time of positioning to point R.
Previous page
Next page

Contents Summary of FS 16/18/160/180-MB Concerning the Correction of Rigid Tapping (G84) / Left-handed rigid tapping cycle (G74) Supplement to Manual

  • Page 1TECHNICAL REPORT NO.TMN 02/081E Date Aug. 21, 2002 General Manager of Software Development Center FANUC Series 16/18-MA/MB/MC FANUC Series 16i/18i/21i-MA/MB,18i-MB5 FANUC Series 0-M/0i-MA/21-MB/20i-FA Concerning the correction of Rigid tapping (G84) / Left-handed rigid tapping cycle (G74) 1. Communi
  • Page 2FANUC Series 16/18/160/180-MB OPERATOR'S MANUAL FANUC Series 16/18 FOR MACHINIG CENTER OPERATOR'S MANUAL Concerning the correction of Rigid tapping (G84) / Left-handed rigid tapping (G74) 1.Type of applied technical documents FANUC Series 16/18/160/180-MB OPERATOR'S MANUAL Name FANUC Series 16/18 FO
  • Page 3Outline Descriptions are changed as follows. 1. The description of "Thread lead" on "14.2.1 Rigid tapping (G84)" is replaced. 2. The description of "Thread lead" on "14.2.2 Left-Handed Rigid tapping Cycle (G74)" is replaced. Details 1. The description of "Thread lead" on "14.2.1 Rigid tapping (G84)"