Method for opening the lower cover of the Servo Amplifier alpha i series. Additional Manual Page 1
Additional Manual
TECHNICAL REPORT (MANUAL) NO. TMS01/052E
Date: Dec.19, 2001
General Manager of
Servo Laboratory
Method for opening the lower cover of the Servo Amplifier αi series.
1. Communicate this report to:
O Your information only (including RD,YD,POD,SBAR)
O GE Fanuc-N, GE Fanuc-E
O FANUC Robotics
MILACRON
O Machine tool builder
Sales agency
O End user
2. Summary for Sales Documents
3. Notice
4. Attached Document
Drawing
NO.
A-53866E-410
IDE
Original section of issue
Vice General
Manager
Department
Manager
Section
Manager
Person in
Charge
FANUC
Contents Summary of Method for opening the lower cover of the Servo Amplifier alpha i series. Additional Manual
- Page 1TECHNICAL REPORT (MANUAL) NO. TMS01/052E Date: Dec.19, 2001 General Manager of Servo Laboratory Method for opening the lower cover of the Servo Amplifier αi series. 1. Communicate this report to: O Your information only (including RD,YD,POD,SBAR) O GE Fanuc-N, GE Fanuc-E O FANUC Robotics MILACRON O
- Page 2Method for opening the lower cover of the FANUC Servo Amplifier α i series In the FANUC Servo Amplifier αi series there is a projection for locking the lower cover on the right side of it. If you open the lower cover, you must take off the projection. Method for opening the lower cover is as follows
- Page 3[Method for taking off the lower cover] If you want to take off the lower cover for reasons of wiring easily etc., turn the cover at 90 degrees and pull out it softly. Show the following picture. Note) After the work finished, please put the cover back by means of reverse process of above. Method fo