
A-79613E
Title
Draw
No.
Ed. Date Design Description
Date
June.02.’04 Design. Apprv.
11/11
Page
F
NUC Series 30i
31i
32i
-MODEL A
Cs contour control axis coordinate
establishment
Alarm and message
Number Message Description
PS5346 RETURN TO REFERENCE
POINT
Cs coordinate establishment was aborted.
Perform manual reference point return of Cs axis.
1. CSFIx was set to 1 when Cs axis zero point establishment
state signal CSPENx is 0.
2. Position data was not transferred from spindle amplifier.
3. Servo off is activated at start of Cs axis coordinate
establishment.
4. Cs axis is under synchronous control or superimposed
control.
5. Emergency stop is applied during Cs axis establishing
coordinate.
6. Composite control of Cs axis is released during Cs axis
establishing coordinate.
7. Synchronous/composite/superimposed control starts
during Cs axis establishing coordinate.