1. Fanuc
  2. FS16i/18i/21i-MA, FS16i/18i-TA Extended superimposed control of PMC axis

FS16i/18i/21i-MA, FS16i/18i-TA Extended superimposed control of PMC axis Additional Manual Page 2

Additional Manual
Ed.
Page
Name
No.
Date Contents
Draw up
FS16
i
/18
i
/21
i
-MA, FS16
i
/18
i
-TA
Extended superimposed control of PMC
axis
A-78498
2001.05.18
2/5
1
Extended Superimposed control of PMC axis
This function enables running of CNC program as continuously as possible in the
superimposed control of a PMC axis function included the Extension of PMC axis
control.
Previous page
Next page

Contents Summary of FS16i/18i/21i-MA, FS16i/18i-TA Extended superimposed control of PMC axis Additional Manual

  • Page 1Table of Contents 1.1 Outline ................................................................................................ 3 1.2 Explanation........................................................................................ 4 Name FS16i/18i/21i-MA, FS16i/18i-TA Extended superimposed control
  • Page 21 Extended Superimposed control of PMC axis This function enables running of CNC program as continuously as possible in the superimposed control of a PMC axis function included the Extension of PMC axis control. Name FS16i/18i/21i-MA, FS16i/18i-TA Extended superimposed control of PMC axis No. A-7849
  • Page 31.1 Outline The CNC program waits until the end of the PMC superimposed axis moving in the current superimposed control of a PMC axis. CNC PMC Moving X-axis by superimposed command O0001; start O0001 N100 G97 M12; N110 G00 Z100.; N120 G01 Z150. F150.; N130 X150.; N140; ; stop X-axis ; M30; % The abo
  • Page 41.2 Explanation Command which can run continuously ● The block with no motion. (e.g. block of auxiliary function, dwell, O/N number, EOB, and so on) ● The cutting feed block. ● The rapid traverse block with no command of superimposed axis. Command which waits until the end of PMC axis moving ● The r
  • Page 5Parameter #7 #6 #5 #4 #3 #2 #1 #0 8006 ESI [Data type] Bit ESI Extended superimposed control of PMC axis function is 1: Enabled 0: Disabled Name FS16i/18i/21i-MA, FS16i/18i-TA Extended superimposed control of PMC axis No. A-78498 Ed. Date Contents Page 5/5 Draw up 2001.05.18