FANUC Power Mate-D/H The way of measure when the ladder graphic display is not good on the monochrome LCD Additional Manual Page 2
Additional Manual
Edit Date
Design
FANUC Power Mate-MODEL D/H
The way of PMC’s measure on the
monochrome LCD
A-77761E
Page2/3
Description
Title
Draw
1. OUTLINE
This document describes the way of measure when the ladder graphic display is not good on the
monochrome LCD of Power Mate-MODEL D/H and applied software series and editions.
2. Applied software
・Power Mate–MODEL D
Software Series Edition
Power Mate-MODEL D（１path）
８８３８ ０１(Ａ) or later
Power Mate-MODEL D（２path）
８８３９ ０１(Ａ) or later
・Power Mate-MODEL H
Software Series Edition
PMC-PA3 control software
４０７８ ０５(Ｅ) or later
Ladder editing card ４０７９ ０２(Ｂ) or later
3. Setting in case of using the monochrome LCD
If the ladder diagram display is not good on the monochrome LCD , please set bellow:
・Set the bit 3 of keep relay K19 to "1" , and turn off and on the power supply.
#7 #6 #5 #4 #3 #2 #1 #0
K19
LCD-MONO
#3 LCD-MONO 0 : It is displayed by the difference of the brightness on the
monochrome
LCD.
1 : It is displayed by the reverse display on the monochrome LCD.
Note
Ladder editing card can not be used.
Note
This parameter becomes effective at the next power on after the
setting is changed.
Please turn off and on the power supply again after you change
the parameter setting.
Contents Summary of FANUC Power Mate-D/H The way of measure when the ladder graphic display is not good on the monochrome LCD Additional Manual
- Page 1TECHNICAL REPORT (MANUAL) Ｎｏ．ＴＭＮ９９／045E Date 1999. General Manager of Software Laboratory ＦＡＮＵＣ Ｐｏｗｅｒ Ｍａｔｅ－Ｄ／Ｈ The way of measure when the ladder graphic display is not good on the monochrome LCD １．Communicate this report to : ○ Your information ○ GE Fanuc-N, GE Fanuc-E FANUC Robotics CINCINNATI MIL
- Page 21. OUTLINE This document describes the way of measure when the ladder graphic display is not good on the monochrome LCD of Power Mate-MODEL D/H and applied software series and editions. 2. Applied software ・Power Mate–MODEL D Software Series Edition Power Mate-MODEL D（１path） ８８３８ ０１(Ａ) or later Powe
- Page 3You can use the setting parameter display for above mentioned change. PMC PRM (SETTING) MONIT RUN PROGRAMMER ENABLE = 0(0:NO 1:YES) (K17.1) LADDER START = 0(0:AUTO 1:MANUAL) (K17.2) RAM WRITE ENABLE = 0(0:NO 1:YES) (K17.4) SIGNAL TRACE START = 0(0:MANUAL 1:AUTO) (K17.5) DATA TBL CNTL SCREEN= 0(0:YES