1. Fanuc
  2. FANUC Power Mate-D/H The way of measure when the ladder graphic display is not good on the monochrome LCD

FANUC Power Mate-D/H The way of measure when the ladder graphic display is not good on the monochrome LCD Additional Manual Page 3

Additional Manual
Edit Date
Design
FANUC Power Mate-MODEL D/H
The way of PMC’s measure on the
monochrome LCD
A-77761E
Page3/3
Description
Title
Draw
You can use the setting parameter display for above mentioned change.
GRAY SCALE DISPLAY
This is a way of setting the ladder graphic display on the monochrome LCD.
If the display on the monochrome LCD is not good , then please change the setting.
If “USE” is selected, it is displayed by the difference of the brightness.
If “UNUSED” is selected, it is displayed by the reverse display.
PMC PRM (SETTING) MONIT RUN
PROGRAMMER ENABLE = 0(0:NO 1:YES)
(K17.1)
LADDER START = 0(0:AUTO 1:MANUAL)
(K17.2)
RAM WRITE ENABLE = 0(0:NO 1:YES)
(K17.4)
SIGNAL TRACE START = 0(0:MANUAL 1:AUTO)
(K17.5)
DATA TBL CNTL SCREEN= 0(0:YES 1:NO)
(K17.7)
SIGNAL TRIGGER START= 0(0:MANUAL 1:AUTO)
(K18.2)
GRAY SCALE DISPLAY = 0(0:USE 1:UNUSED)
(K19.3)
Note
This parameter becomes effective at the next power on after the
setting is changed.
Please turn off and on the power supply again after you change
the parameter setting.
Previous page
Next page

Contents Summary of FANUC Power Mate-D/H The way of measure when the ladder graphic display is not good on the monochrome LCD Additional Manual

  • Page 1TECHNICAL REPORT (MANUAL) Ｎｏ．ＴＭＮ９９／045E Date 1999. General Manager of Software Laboratory ＦＡＮＵＣ Ｐｏｗｅｒ Ｍａｔｅ－Ｄ／Ｈ The way of measure when the ladder graphic display is not good on the monochrome LCD １．Communicate this report to : ○ Your information ○ GE Fanuc-N, GE Fanuc-E FANUC Robotics CINCINNATI MIL
  • Page 21. OUTLINE This document describes the way of measure when the ladder graphic display is not good on the monochrome LCD of Power Mate-MODEL D/H and applied software series and editions. 2. Applied software ・Power Mate–MODEL D Software Series Edition Power Mate-MODEL D（１path） ８８３８ ０１(Ａ) or later Powe
  • Page 3You can use the setting parameter display for above mentioned change. PMC PRM (SETTING) MONIT RUN PROGRAMMER ENABLE = 0(0:NO 1:YES) (K17.1) LADDER START = 0(0:AUTO 1:MANUAL) (K17.2) RAM WRITE ENABLE = 0(0:NO 1:YES) (K17.4) SIGNAL TRACE START = 0(0:MANUAL 1:AUTO) (K17.5) DATA TBL CNTL SCREEN= 0(0:YES