Constant-acceleration-time Acceleration/Deceleration for Interpolation-type Positioning Additional Manual Page 4
Additional Manual
Edit
A-77436E
FANUC Series 16
i
/18
i
/21
i
Constant-acceleration-time-manner
Acceleration/deceleration for Interpolation-type
4/4
Title
Drawin
g
No.
Pa
g
e
Data Si
g
nature Descri
p
tion
1998/10/2
No.
1620
Time constant of linear acceleration/deceleration in rapid traverse for
each axis
[Data type] Word axis
[Data unit] msec
[Data range] 0 to 4096 in total for all controlled axes
[Example]
If the number of controlled axes is 4, the following setting can be done:
1st axis: 2048 msec
2nd axis: 1024 msec
3rd axis: 512 msec
4th axis: 512 msec
Total time constants = 2048 + 1024 + 512 + 512 = 4096
4. Note
When bell-shaped acceleration/deceleration is selected, this function is not available.
Contents Summary of Constant-acceleration-time Acceleration/Deceleration for Interpolation-type Positioning Additional Manual
- Page 1FANUC Series 16i/18i/21i Constant-acceleration-time Acceleration/deceleration for Interpolation-type Positioning Specifications [Contents] 1. Outline ------------------------------------------------- 2. 2. Specification ------------------------------------------------- 2. 3. Parameters -------------
- Page 21.Outline This function enables acceleration/deceleration for interpolation-type positioning (parameter No. 1401#1 LPOS = 1) in constant-acceleration-time manner. As a result, positioning is performed more exactly along the programmed path. 2.Specification Y B A X When positioning from the point A t
- Page 3ii) Constant-acceleration-time (parameter No. 1603#4 RPTCT = 1): In the case that the time constants(parameter No.1620) for X and Y axes are the same. Feedrate X-axis Tim Y-axis Tim Deviation of actual positioning path from the programmed path is smaller than that by constant-acceleration-rate accel
- Page 4No. Time constant of linear acceleration/deceleration in rapid traverse for 1620 each axis [Data type] Word axis [Data unit] msec [Data range] 0 to 4096 in total for all controlled axes [Example] If the number of controlled axes is 4, the following setting can be done: 1st axis: 2048 msec 2nd axis: