1. Fanuc
  2. FANUC Series 30i/31i-MODEL A Specifications for Speed Command Extension in Least Input Increments D and E

FANUC Series 30i/31i-MODEL A Specifications for Speed Command Extension in Least Input Increments D and E Additional Manual Page 1

Additional Manual
A-79510E
Title
Draw
No.
Ed. Date Design Description
Date Sep.10.’04 Design. Apprv.
1/6
page
FANUC Series 30i/31i-MODEL A
Specifications for Speed Command Extension
in Least Input Increments D and E
FANUC Series 30i/31i-MODEL A
Specifications for Speed Command
Extension in Least Input Increments
D and E
Previous page
Next page

Contents Summary of FANUC Series 30i/31i-MODEL A Specifications for Speed Command Extension in Least Input Increments D and E Additional Manual

  • Page 1FANUC Series 30i/31i-MODEL A Specifications for Speed Command Extension in Least Input Increments D and E FANUC Series 30i/31i-MODEL A Title Specifications for Speed Command Extension in Least Input Increments D and E Draw A-79510E No. Ed. Date Design Description page 1/6 Date Sep.10.’04 Design. App
  • Page 2Overview When the least input increment D (IS-D) or E (IS-E) is selected, up to now the limitations indicated in Table 1 and Table 2 are imposed on parameters for speed and acceleration/deceleration. This means that when the unit of data is mm, and the increment system is IS-E, for example, no rapid
  • Page 3- Parameters for speed and angular velocity when this function is used Increment Least data Unit of data Valid data range system increment mm/min IS-D 0.0001 0.0000 to +99999.9999 deg /min IS-E 0.0001 0.0000 to +99999.9999 IS-D 0.00001 0.00000 to +4000.00000 inch/min IS-E 0.00001 0.00000 to +4000.00
  • Page 4Restrictions - Parameters of time constants for linear acceleration/deceleration after interpolation and bell-shaped acceleration/deceleration after interpolation When linear acceleration/deceleration after interpolation or bell-shaped acceleration/deceleration after interpolation is used in rapid t
  • Page 5Parameter #7 #6 #5 #4 #3 #2 #1 #0 1013 IESP [Input type] Parameter input [Data type] Bit axis #7 IESP When the least input increment is D(IS-D) or E(IS-E), the function to allow to set the larger value to the parameter of the speed and the acceleration: 0: Not used. 1: Used. As for the axis which se
  • Page 6#7 #6 #5 #4 #3 #2 #1 #0 2282 ISE64 [Input type] Parameter input [Data type] Bit axis #3 ISE64 The speed limitation of feed forward(Parameter No.2005#1(FEED)=1): 0: Former specification. 1: Extended specification. The feedrate limitation is shown in the following tables, when the feed forward functio