B–63840EN/03
4. DESCRIPTION OF PARAMETERS
185
CCN When automatic reference position return (G28) is specified in the cutter
compensation C mode (M series) or in tool nose radius compensation (T
series):
0 : The tool nose radius compensation vector is cancelled in movement to
an intermediate position.
1 : The tool nose radius compensation vector is not cancelled in
movement to an intermediate position, but is cancelled in movement
to the reference position.
LVC Offset value of tool offset
0 : Not cleared, but held by reset
1 : Cleared by reset
LVK Tool length offset value
0 : Cleared by reset
1 : Not cleared, but held by reset
TGC Tool geometry compensation value
0 : Not canceled by reset
1 : Canceled by reset
(Valid when LVC, #6 of parameter No.5003, is “1”)
#7
Y03
5004
#6 #5 #4 #3
TS1
#2
ODI
#1
ORC
#0
NOTE
When this parameter is set, the power must be turned off
before operation is continued.
[Data type] Bit
ORC Tool offset value
0 : Set by the diameter specification
(Can be set in only the axis under diameter programming)
1 : Set by the radius specification
ODI A cutter compensation amount is set using:
0 : A radius.
1 : A diameter.
TS1 When the tool offset measurement value direct input B function is used,
touch sensor contact detection is based on:
0 : Four–contact input.
1 : One–contact input.
Y03 Y axis offset is:
0 : Used for 4th axis.
1 : Used for 3th axis.
#7
5005
#6
TLE
#5
QNI
#4 #3 #2
PRC
#1 #0
CNI
[Data type] Bit
CNI On the offset screen, Y–axis offset screen, and macro screen, the [INP.C]
soft key is:
0: Used.
1: Not used. (The [INP.C] soft key is not displayed.)