
B–63173EN/03
6. CONNECTION OF I/O UNITS TO
MACHINE INTERFACE
77
Power Mate
Connector panel
CB156
Eight high–speed
DI points
Machine
operator’s
panel
High–
speed DI
signal
The Power Mate has eight high–speed DI signal interface points. They
are accommodated in the CB156 connector, which is also used for the
built–in DI/DO signals. See Section 6.4.1 for the connector specification,
pin assignment, and the cable between the connector and connector panel.
The high–speed DI signal interface shares input pins with the X1003
signals for the built–in DI points. Whether the high–speed DI signal
interface or the built–in DI points use the input pins is specified using a
parameter. So, when the high–speed DI signal interface uses the input
pins, the X1003 signals for the built–in DI points cannot use them.
The high–speed DI signals shall be free of chattering. The following are
requirements for the contacts for the signals on the machine side. (24
VDC system)
Contact capacity:
30 VDC, 16 mA or greater
Open–circuit contact–to–contact leakage:
1 mA or less (for 26.4 V)
Closed–circuit contact–to–contact voltage drop:
3.5 V or less (for 8.5 mA, including a voltage drop across the
cable)
6.5
HIGH–SPEED DI
SIGNAL INTERFACE
6.5.1
General
6.5.2
High–speed DI Signal
Specification