
GFK-1383A Chapter 3 Assembling the Power Mate H 3 - 11
3
Note
It is recommended that you label connector JF1, along with the axis with which it
corresponds. For example, if this connection is to the X axis, place the letter X on
the connector JF1.
If you are connecting more than one motor, do not cross the amplifier and
feedback connections. The first motor must be connected to JF1 on the amplifier,
and JS1B of that amplifier must be connected to AMP1 JS1 on the Power Mate
H. The second motor must be connected to JF1 and JS1B of the servo amplifier
that is connected to AMP2 JS2 on the Power Mate H, and so on for all axes in the
system.
Table 3 - 2. Motor Encoder Feedback Cables
GE Fanuc Severe Duty
Cable
GE Fanuc Cable Motor Model Number
44C742355-001 44C741944-001
α2 only
44C742241-004 44C742162-004
All other α Series motors
44C742435-001 A02B-0200-K802
β0.5 only
44C742355-001 44C741944-001
β2 and β6
Connecting the Motor Brake (Optional)
α and β Series servo motors are available with optional holding brakes. If your motor is equipped
with a brake, you will not be able to rotate the motor shaft by hand.
To connect the brake:
1. Locate cable 44C742238-004, except for β0.5, α1, or α2 motors. (These motors include the
brake wiring as part of the motor power cable.) Attach the end with the connector to the
keyed 3-pin connector on the motor.
2. Connect the other end of the cable to a 90Vdc power supply with specifications as stated in
the motor manuals. The connection information is:
Connector Pin Loose End Description
A +V To supply positive.
B -V To supply negative.
C PE To earth ground.