
5 - 6 Power Mate H Startup Guide - April 1997 GFK-1383A
5
If your Power Mate motion system consists of more than one axis, remember to enter valid values
for the axis-specific parameters for the other axes. Parameters which are axis specific use the form
Parameter Name x, where x signifies the appropriate axis number (1-6 or X, Y, Z, A, B, C, U, V,
W). These axis number labels are defined by the user using parameter #1020 (see Table 5-1).
Parameters with no x axis designation pertain to all axes or are parameter settings which are not
axis related (for example, CRT/MDI, I/O, and COMMUNICATIONS parameters).
Parameters can be in bit-type (binary) or word-type format. Bit-type parameters are used for
parameters which can only be in one of two states (ON/OFF, True/False, Enabled/Disabled).
Word-type parameters are used for parameters requiring a numerical value.
Bit-type parameters are arranged in groups of 8 bits per parameter number (for example:
01100101). Word-type parameters contain decimal values (for example: 47). In bit-type
parameters, bit 7 (#7) is the far-left bit, and bit 0 (#0) is the far-right bit, as shown below:
#7 #6 #5 #4 #3 #2 #1 #0
. . . .
&0012X 0 0 1 1 0 0 1 1
Bit-type parameters are referenced using the form:
para number # bit number
For example, 1004#7 is parameter 1004 bit 7.
The format of the parameters is:
Parameter Number Bit Type Value Word Type Value Parameter Description
&1084 X 00110011
Y 00110100
X47
Y3000
This is not a real setting.
X 00110011 is a bit-type (binary) parameter setting for the first axis (X).
Y 00110100 is a bit-type (binary) parameter setting for the second axis (Y).
X 47 is a word-type parameter setting for the first axis (X).
Y 3000 is a word-type parameter setting for the second axis (Y).
Note
After the parameters are set, make sure to back up the parameters using either a Flash
Memory Card (see Section 3 in the Power Mate-Model H Maintenance Manual, GFZ-
62685EN), Handy File, or via RS-232 communications. Also, remember to update the
parameter backup after changing parameters.