
GFK-1383A 4 - 1
Chapter
Turning On the Power Mate H
Before turning on the power, please review these safety precautions:
• Confirm that the supplied cables are properly attached to the appropriate connectors.
• Confirm that all wiring to the power sources is correct (for example, Pin 1 = (+) and Pin 3 =
(-) for 24Vdc power to Power Mate and Pin 1 = (+) and Pin 2 = (-) for I/O Unit Model A and
CRT/MDI).
• Make sure that the motors are properly secured but are not yet connected to the machine load.
• Check that all components are properly grounded.
• If you are using more than one motor, confirm that the servo motor power cables and
feedback cables are not crossed between motors. Labeling the cable connectors (JSx and JFx)
by the axis they are associated with will help.
There is a specific sequence for turning on power to the Motion Control System. In the order
listed, perform the following steps:
1. Turn on the 230Vac input power to the servos.
2. Apply power to the CRT/MDI operator's display terminal if you are using one of these units.
3. If you are using an I/O Unit Model A, apply the 24Vdc power source.
4. Apply 24Vdc power to the Power Mate H.
For more information, see Section I.5 of the Power Mate H Connection Manual, GFZ-62683EN.
If an alarm or error message is displayed on your operator input device (CRT/MDI or DPL/MDI),
do not be concerned. You will correct that when you:
Configure the Power Mate H !
4