
9.NOTES ON MOTOR INSTALLATION FANUC AC SPINDLE MOTOR αiT SERIES B-65272EN/04
- 202 -
9.5 ROTATION JOINT
When coolant is flown through the through hole of the motor shaft, a
coolant pressure acts on the end face of the coolant joint attached to
the shaft front end, thus producing a thrust load that pushes the motor
shaft backward. (See Section 9.6.)
If a rotation joint of separate external support type is attached to the
motor shaft rear end, a coolant pressure acts also on the rotation joint
to push the motor shaft forward, and therefore the thrust load can be
canceled.
The αi
T series is designed assuming that a rotation joint indicated in
the table below is attached to the shaft rear end:
Rotation joints of separate external support type manufactured by
Deublin or Rix.
Motor model
α1.5i
T to α3iT α6iT to α22iT
Mounting screw size
M12 × 1.25 (left-hand screw) M16 × 1.5 (left-hand screw)
Piping direction
Straight type Elbow type Straight type Elbow type
Specification of Deublin
1129-320-327 1129-014-327 1129-320-301 1129-014-301
Specification of Rix
ESX20M-6793 ESX20M-7248 ESX20M-6902 ESX20M-7308
Function
(Caution)
Spindle-through coolant during rotation or stopping
Air-through during stopping
(Air-through disabled during rotation)
CAUTION
For details of the rotation joint function, the method
of attaching rotation joints, and rotation joints
capable of air-through during rotation, contact the
following company:
For rotation joints and support housings, contact:
Deublin Japan Corporation TEL: 0727-57-0099
Rix corporation TEL: 092-472-7312, E-mail : intl-trade@rix.co.jp
Rotation
side
Separated
Stationary
side
Contact
When coolant is off
When coolant is on
Example of rotation joint (separate external support type)
* Before attaching a rotation joint to the motor shaft, apply screw
locking adhesive.