
B-65272EN/04 SPECIFICATIONS FOR THE αi SERIES 6.DETERMINING THE ACCELERATION TIME
- 33 -
6 DETERMINING THE ACCELERATION
TIME
The time required for each acceleration for the acceleration/
deceleration output characteristics shown below can be obtained from
the following equation.
Since machine load torque is not taken into consideration, the actual
time is slightly longer than the calculated time.
Output
kW
Pf
Pm
0
Nb Nf Nm
Speed
cceleration/deceleration output characteristics (Note)
(1) (2) (3)
J
L
: Load inertia converted for the motor shaft [kgf⋅m⋅s
2
]
Jm : Motor inertia [kgf⋅m⋅s
2
]
Pf, Pm : Output [kW]
Nb, Nf, Nm : Speed [min
-1
]
NOTE
Obtain an output value at acceleration time
according to the following methods:
- When a maximum output value at acceleration
time is shown in the output characteristics
diagram, use the value.
- When an αCi series motor is used or if the
machine load torque is high, use the 30-minute
rated output as is.
- In other cases
The target output during
acceleration/deceleration is 1.2 times the 30-
minute rated output of each model (10- or 15-
minute rated output for some models).